This is the area of the factory where the plastic components that make up the Optical Computer Mouse are made. Each machine makes a different component. To learn more about any of the components click on the corresponding label next to each of the injection molding machines.

In the Injection Molding Department, the following problems can occur:

List of potential defects:

-Injection Molded Components (Single polymer) Cover, Buttons, Bottom, Scroll Base, Diffuser:

Special Cause:

Common Cause:

Flash

Scratches or Dents in mold cavity

Bad raw material

Incorrect color

Voids

Incomplete Part

Deformation while cooling

Extractor pin indentations

Machine breakdown

 

Click Here To Go Back To Index Page.